NAUTA scientific

sensing your world

Towed hydrophones

Assembled with sensors aimed at detecting acoustic signals, and vibrations in general, in water, towed arrays are designed in order to minimize unwanted hydrodinamic noise.
Towed hydrophone are usually made of more than one sensor, in order to receive information about the direction from where a signal arrives. Two main techniques are used to get this information: beamforming and time delay measure.
While beamforming requires high processing capabilities and returns excellent results (and this usually means BIG computers and quite a lot of money), time delay measure is a rather simple but yet effective technique, requiring a simple PC and suitable software. We have archived on these pages images and ideas about arrays we have designed and assembled in the past.
Hope they may be of some help if you are thinking about towed hydrophones for Marine Mammal research.
Stacks Image 530

Stacks Image 528

Stacks Image 32

FarONE - 2018

"Single element" towable hydrophone.
Assembled with a 50kHz sensor and low noise preamp electronics, powered via standard phantom power, using a long (150 meters as standard) balanced signal transmission line (to give reasonable immunity to electric noise), to be connected to anything with a standard professional MIC input with phantom power.

This system is aimed at helping "low-budget" researchers willing to get an underwater acoustic snapshot of the study area, operating from slowly moving sailing boats or from fixed coastal stations up to 500 meters from the listening point.
This hydrophone, codenamed FarONE, is branded by Nauta-rcs.

Details HERE.
In 2009/2010 we made two new towed hydrophones models

Based on the same sensors, manufactured in the UK, they differ in cable lenght (110m and 220m) and in additional features (a pair of extra hydrophones for stereo listening while free drifting, different plastic cases, different audio amplifiers).
This is our standard setup for 2009/2010.
Stacks Image 33

Codenamed PROTONE (PROTotype ONE), this was our test towed hydrophone.
Do not even remember how many times we have changed the sensors on this.
In 2008 it got entangled into a propeller and was lost. It had four sensors, and could be equipped with up to eight. One pressure gauge, and a nice modification to accomodate a temperature transmitter.
Lessons learnt: on a prototype you will need more wires than how you have.
Stacks Image 35

Codenamed G4 (generation four), was our standard commercial towed hydrophone in 2004/2005. Originally re-designed for a big NGO, this is our standard product at the time of writing. Analog part going from about 100Hz to 60kHz and then again from 100kHz to 230kHz, and a digital acquisition interface, with filters, going from 0Hz to 48kHz, offers an high frequency output, for click detectors. It is packed with software, and is worth the money!
Lessons learnt: Let's provide training. Longer tow cable means lower noise and deeper sensor. Where thermocline is an issue, you need deep sensors.
Stacks Image 39
Stacks Image 36
Stacks Image 37
G5 - TAOH. Year 2006.
Manufactured with three elements (two wideband, high-pass filtered; one wideband, no filters), is our configuration for low budget systems during spring 2006.
Here you can see the manual.
Stacks Image 38

We make a very very basic use of cookies, just to ensure a smooth navigation. No personal data are collected out of the e-commerce functions, and no use of personal data is made out of the e-commerce functions themselves.